| 173
Ambrogio Drive Gurnee, IL 60031 Ph: (847) 263-9000 Fx: (847) 263-9090 |
|
| |
|
| Old Trail Printing “We have used
this technology for a few weeks now and have found the machine to be
every bit as accurate as promised when properly calibrated for each
ink component.” … Hallmark Card “The system
is very accurate and very repeatable, which is what we were hoping for,
This system was justified on a material savings due to the tube construction
and the lack of driers, we expect to utilize 98% of the ink, where as
with 5 lb cans, we only got between 60-70% utilization due to ink skinning
over.
…” It quickly became apparent that this machine had many advantages over seemingly similar machines that exist in the market. The Magnum’s design, construction and operation are all very simple.” This simplicity gives us the following benefits: 1.
The Evolve Pro software on the Magnum is extremely simple to navigate,
and to use, allowing unskilled operators to dispense batches. …“Delivery
times for these batches from a local branch typically take from 4-8
hours. The Magnum has allowed our customer sites to use Standard blending
bases, which can be between 25% and 50% less expensive than ordering
a small batch special from the local branch. If the press run is very
small, one or two lbs is usually sufficient to fill the press. The customers
are now not limited by minimum order quantities, or put in a position
where they have to wait for most of a shift for a color for a job that
could be on press in the next half hour. If the customer needs a standard
PMS color, or a small quantity of a special color that has be formulated
previously, a batch can be dispensed and mixed in about 15 minutes.
This lets the customer be on press much sooner than if they ordered
from the local INX branch, at a much lower cost than if they had ordered
a special. Dan Babe, Dir. Customer Engineering
Services, Milwaukee, WI.
|
![]() |
Copyright
2006© GFI Innovations, Inc. |